1. Junji Tagami

    0 Comments Leave a Comment

    1-15 of 68 1 2 3 4 5 »
    1. Mentioned In 68 Articles

    2. Assessment of enamel cracks at adhesive cavosurface margin using three-dimensional swept-source optical coherence tomography

      Assessment of enamel cracks at adhesive cavosurface margin using three-dimensional swept-source optical coherence tomography
      Objectives Swept-source optical coherence tomography (SS-OCT) can construct cross-sectional images of internal biological structures. The aim of this study was to evaluate enamel cracks at the cavosurface margin of composite restorations using SS-OCT. Methods Bowl-shaped cavities were prepared at two locations (mid-coronal and cervical regions) on the enamel surface of 60 bovine teeth. Half of the cavities (30) were treated with phosphoric acid gel. A two-step self-etch adhesive (Clearfil SE ...
      Read Full Article
    3. A pilot study to assess the morphology and progression of non-carious cervical lesions

      A pilot study to assess the morphology and progression of non-carious cervical lesions
      Objective This longitudinal pilot study aimed to morphologically and quantitatively investigate the progress of non-carious cervical lesions (NCCLs) by using swept-source optical coherence tomography (SS-OCT). Methods The samples examined comprised sets of NCCL epoxy resin replicas obtained from 10 lesions in 6 patients who attended annual dental visits over 4 or 5 years. SS-OCT images of the replicas were analyzed in terms of the maximum depth (D max ) and corresponding ...
      Read Full Article
    4. Three-Dimensional Analysis of Enamel Crack Behavior Using Optical Coherence Tomography

      Three-Dimensional Analysis of Enamel Crack Behavior Using Optical Coherence Tomography
      The aim of this study was to nondestructively analyze enamel crack behavior on different areas of teeth using 3D swept source-optical coherence tomography (SS-OCT). Ten freshly extracted human teeth of each type on each arch ( n = 80 teeth) were inspected for enamel crack patterns on functional, contact and nonfunctional, or noncontact areas using 3D SS-OCT. The predominant crack pattern for each location on each specimen was noted and analyzed. The ...
      Read Full Article
    5. Optical analysis of enamel and dentin caries in relation to mineral density using swept-source optical coherence tomography

      Optical analysis of enamel and dentin caries in relation to mineral density using swept-source optical coherence tomography
      The aim of this study was to evaluate the signal intensity and signal attenuation of swept source optical coherence tomography (SS-OCT) for dental caries in relation to the variation of mineral density. SS-OCT observation was performed on the enamel and dentin artificial demineralization and on natural caries. The artificial caries model on enamel and dentin surfaces was created using Streptococcus mutans biofilms incubated in an oral biofilm reactor. The lesions ...
      Read Full Article
    6. Assessment of bacterial demineralization around composite restorations using swept-source optical coherence tomography (SS-OCT)

      Assessment of bacterial demineralization around composite restorations using swept-source optical coherence tomography (SS-OCT)
      Objective To observe the bacterial demineralization of the enamel and dentin around composite restorations bonded with one-step and two-step self-etch adhesive systems using swept-source optical coherence tomography (SS-OCT). Methods Forty class V cavities (2.5-mm surface diameter, 2.0-mm maximum depth) were prepared on cervical areas of 20 human molars. The specimens were either treated with one-step adhesive (Clearfil Tri-S Bond ND Quick; TS) or two-step adhesive (Clearfil SE Bond ...
      Read Full Article
    7. Monitoring of cariogenic demineralization at the enamel–composite interface using swept-source optical coherence tomography

      Monitoring of cariogenic demineralization at the enamel–composite interface using swept-source optical coherence tomography
      Objectives The aim of this study was to evaluate enamel demineralization at composite restoration margins caused by cariogenic biofilm using swept-source optical coherence tomography (SS-OCT). Methods Sixty round-shaped cavities were prepared on the mid-buccal enamel surface of extracted human molars. The cavities were restored with Estelite Flow Quick flowable composite using either Clearfil SE Bond or Clearfil Tri-S Bond ND bonding agents. Streptococcus mutans suspension was applied to form a ...
      Read Full Article
    8. Internal adaptation of resin composites at two configurations: Influence of polymerization shrinkage and stress

      Internal adaptation of resin composites at two configurations: Influence of polymerization shrinkage and stress
      Objective This study compared internal adaptation of composites under different C-factors and examined the relationship between internal adaptation and polymerization shrinkage parameters. Methods Cylindrical cavities 3 mm in diameter were prepared in 100 human third molars in two depths: 4 mm high C-factor (H-CF) or 1 mm low C-factor (L-CF). After adhesive application (Clearfil SE One, Kuraray Noritake), the composite was placed in two increments in three subgroups: Filtek Supreme ...
      Read Full Article
    9. The role of enamel thickness and refractive index on human tooth colour

      The role of enamel thickness and refractive index on human tooth colour
      Objectives To investigate the role of enamel thickness and refractive index ( n ) on tooth colour. Methods The colour and enamel thickness of fifteen extracted human central incisors were determined according to CIELab colour scale using spectrophotometer (Crystaleye) and swept-source optical coherence tomography (SS-OCT), respectively. Subsequently, labial enamel was trimmed by approximately 100 m, and the colour and remaining enamel thickness were investigated again. This cycle was repeated until dentin appeared ...
      Read Full Article
    10. Assessment of occlusal fissure depth and sealant penetration using optical coherence tomography

      Assessment of occlusal fissure depth and sealant penetration using optical coherence tomography
      Swept source optical coherence tomography (SS-OCT) is an interferometric imaging technique. This study aimed to assess SS-OCT as a diagnostic tool for the evaluation of occlusal fissure depth and sealant penetration into fissure. Seventy investigation sites of occlusal fissures without visible evidence of caries were categorized into four groups (smooth, shallow, intermediate, and deep fissures). Categorization utilized two methods: 1) visually, using a computer screen, and 2) using SS-OCT images ...
      Read Full Article
    11. Fractography of interface after microtensile bond strength test using swept-source optical coherence tomography

      Fractography of interface after microtensile bond strength test using swept-source optical coherence tomography
      Objective To determine the effect of crosshead speed and placement technique on interfacial crack formation in microtensile bond strength (MTBS) test using swept-source optical coherence tomography (SS-OCT). Materials and methods MTBS test beams (0.9 0.9 mm 2 ) were prepared from flat human dentin disks bonded with self-etch adhesive (Clearfil SE Bond, Kuraray) and universal composite (Clearfil AP-X, Kuraray) with or without flowable composite lining (Estelite Flow Quick, Tokuyama ...
      Read Full Article
    12. Assessment of cervical demineralization induced by Streptococcus mutans using swept-source optical coherence tomography

      Assessment of cervical demineralization induced by Streptococcus mutans using swept-source optical coherence tomography
      Exposed root surfaces due to gingival recession are subject to biofilm stagnation that can result in caries formation. Cervical enamel and dentin demineralization induced by a cariogenic biofilm was evaluated using swept-source optical coherence tomography (SS-OCT). The cementoenamel junction (CEJ) sections of extracted human teeth were subjected to demineralization for 1, 2, or 3 weeks. A suspension of Streptococcus mutans was applied to form a cariogenic biofilm using an oral ...
      Read Full Article
    13. Assessment of Self-Adhesive Resin Composites: Nondestructive Imaging of Resin–Dentin Interfacial Adaptation and Shear Bond Strength

      Assessment of Self-Adhesive Resin Composites: Nondestructive Imaging of Resin–Dentin Interfacial Adaptation and Shear Bond Strength
      Shear bond strength (SBS) and the interfacial adaptation (IA) of self-adhesive resin (SAR) composites to dentin were evaluated. Two SARs [Vertise Flow (VTF) and Fusio Liquid Dentin (FLD)] were evaluated and compared with a conventional restorative system [adhesive: OptiBond FL and composite: Herculite Prcis (OBF/HP)]. Human third molars were used for SBS testing and IA imaging (n=7) using optical coherence tomography (OCT). Flattened dentin disks were prepared and ...
      Read Full Article
    14. Non-destructive evaluation of an internal adaptation of resin composite restoration with swept-source optical coherence tomography and micro-CT

      Non-destructive evaluation of an internal adaptation of resin composite restoration with swept-source optical coherence tomography and micro-CT
      Swept-source optical coherence tomography (SS-OCT) and micro-CT can be useful non-destructive methods for evaluating internal adaptation. There is no comparative study evaluating the two methods in the assessment of internal adaptation in composite restoration. The purpose of this study was to compare internal adaptation measurements of SS-OCT and micro-CT. Two cylindrical cavities were created on the labial surface of twelve bovine incisors. The 24 cavities were randomly assigned to four ...
      Read Full Article
    15. Assessment of current adhesives in class I cavity: Nondestructive imaging using optical coherence tomography and microtensile bond strength

      Assessment of current adhesives in class I cavity: Nondestructive imaging using optical coherence tomography and microtensile bond strength
      Objectives To evaluate the sealing ability and the microtensile bond strength (MTBS) of different adhesive systems bonded to dentin in class I cavities. Methods Round tapered dentin cavities (3-mm diameter, 1.5-mm height) prepared in extracted human molars were restored using composite resin (Clearfil Majesty Posterior) with two-step etch-and-rinse adhesive system (Adper Single Bond 2: ASB2), two-step self-etch adhesive (Clearfil SE Bond: CSEB), all-in-one adhesives (G-Bond Plus: GBP; Tri-S Bond ...
      Read Full Article
    16. Interfacial Adaptation of Composite Restorations Before and After Light Curing: Effects of Adhesive and Filling Technique

      Interfacial Adaptation of Composite Restorations Before and After Light Curing: Effects of Adhesive and Filling Technique
      Purpose: To investigate the effects of placement technique and adhesive material on adaptation of composites before and after light curing. Materials and Methods: Cylindrical cavities (3 mm diameter, 1.7 mm depth) in extracted human molars were restored in 6 groups (n = 5) using 2 adhesives - two-step self-etching Clearfil SE Bond 2 (SE2) and all-in-one Clearfil Tri-S Bond Plus (TSP) (Kuraray Noritake Dental) - and 2 composites - Estelite Sigma Quick (ESQ ...
      Read Full Article
    17. 1-15 of 68 1 2 3 4 5 »
  1. Categories

    1. Applications:

      Art, Cardiology, Dentistry, Dermatology, Developmental Biology, Gastroenterology, Gynecology, Microscopy, NDE/NDT, Neurology, Oncology, Ophthalmology, Other Non-Medical, Otolaryngology, Pulmonology, Urology
    2. Business News:

      Acquisition, Clinical Trials, Funding, Other Business News, Partnership, Patents
    3. Technology:

      Broadband Sources, Probes, Tunable Sources
    4. Miscellaneous:

      Jobs & Studentships, Student Theses, Textbooks
  2. About Junji Tagami

    Junji Tagami

    Junji Tagami, D.D.S., Ph.D. is professor and Chair of the Cariology and Operative Dentistry department at Tokyo Medical and Dental University.